|
|
|
| Linear Bushing is used with grease lubrication or oil
lubrication but in some case, it is used without any lubrication. |
 |
| Before applying the grease, the anticorrosive oil must
be removed by kerosene or organic solvent, and applying the grease
after drying. Must Applying grease directly on the ball for both side
seled type (UU), and applying same as above or applying on the shaft
for without sealed type. Lithium soap radical of viscosity mark (JIS
No.2) is recommended for use. |
 |
| Operating Temp |
Viscosity |
| -30℃ ~ 50℃ |
VG 15 ~ 46 |
| 50℃ ~ 80℃ |
VG 46 ~ 100 |
|
There is no need ti remove anticorrosive oil when oil is used for
lubrication. ISO viscowity grade VG15~100 oil is usually used according
to the temperature. The turbine oil, machine oil, and spindle oil
are usually used as lubrication oil. Drop the oil on the shaft for
lubrication, or supply it through an oil hole provided on the housing(Fig
6). However, droppong lubrication is not used in both seal type because
the seal remove oil, because. Contact SAMICK for Lnear Bushing sith
lubrication hole for user's dermands. |
 |
| Linear Bushing has balls as rolling elements, so it
gives rise to reduces the frictional resistance. Static fricion, in
particular, is very low, and there is just there little diffenence
between static and dynamic friction, so that stick-slip does not occur.
Such low friction makes submicron feeding possible. The normal friction
coefficiebt is on Fig below and Friction resistance can be calculated
by following equation. |
 |
 |
 |
|
Home > Technical Information
> SAMICK LINEAR BUSHING > Lubrication and Friction
